Garage Door Stop Molding – Firts, close the garage door fully. Measure the top of the garage door opening between the left and right corners with a tape measure. Transfer the measurement to the longest of the three pieces of doorstop. Cut solid part of the door stop. For vinyl weathers to curve slightly over the face of the garage door. Place the end you keep on top of the door frame, and drive a brad nails into molding and door frame halfway with a hammer.
Move down to the center of the garage door stop molding and drive a nail in halfway. Do the same on your page helps hold. For trim to look uniform across the top of the opening. Nail stop molding in place with Brad nails. Measure both jambs of the opening from the floor to the corner of the upper stop molding. Transmit the measurements to the remaining two pieces of stop casting. Cut molding to size. Place the top jamb molding to the corner of the top molding.
12 Photos Gallery of: Garage Door Stop Molding Installing
The jamb garage door stop molding should be flush with the side of the top molding. Tack molding the jamb with a brad nail and hammer. Move down halfway and place jamb molding as needed, so that molding is straight, and the vinyl trim folds across the face of the door. Tack middle of the casting into the jamb and eventually line up the bottom of the upright molding. Nail both parts of the jamb stop molding surely stands. Using a 1/8 inch bead of silicone sealant around the periphery of the door stop, where it meets the door frame by means of a caulking gun.98OE