Cut and Install Door Molding Ideas

Mar 12th

Door molding ideas – Die Casting covers the space between the door frame and sheet rock. The casting also adds a decorative detail that makes the door stand out. Molding is available in a variety of styles and varieties. Moldings come in paint grade or stain grade. Paint-quality is made of a lot of small pieces glued together; painting class is a piece of wood. Do-it-yourself handyman can cut and install die casting with little difficulty.

Top Door Molding Ideas
Top Door Molding Ideas

Draw a 3/16 inch reveal around the door frame. It reveals will give you a reference line to put the door molding ideas against. It reveals the amount of the frame which is visible. Use a combination square to mark it. Measure the distance between the two vertical revealing lines.  Measure the length of revealing lines on the sides of the door. Measure from the finish floor up to the reveal lines intersect at the top of the door. This is the inner dimension of the two vertical pieces molding. Set the miter saw to 45 degrees and cut miter joint for each piece of casting. The miter joint angles outward from each of the internal dimensions. Make sure you check the inside edge of the molding with the dimensions. Install the molding on the top of the door first. Place the inside edge of the molding along the 3.16 inch revealing line; ends should touch the intersection reveals lines.

12 Photos Gallery of: Cut and Install Door Molding Ideas

Image of: Top Door Molding Ideas
Image of: Stylish Door Molding Ideas
Image of: Simple Door Molding Ideas
Image of: Popular Door Molding Ideas
Image of: Nice Door Molding Ideas
Image of: Modern Door Molding Ideas
Image of: Door Molding Ideas Style
Image of: Door Molding Ideas Picture
Image of: Door Molding Ideas Image
Image of: Best Door Molding Ideas
Image of: Awesome Door Molding Ideas
Image of: Amazing Door Molding Ideas
 

Install the two side members of the casting in the same way, but adds a layer of wood glue to the miter cut prior to installation. Run a finishing nail into a side of the casting into the adjacent molding to connect the corners. Wipe off any excess glue and put any nails that are not in the face of casting with a nail set and hammer. Apply a thin layer of painters caulk around lists and fill nail holes with wood putty. Grind the dry kit is flush with the door molding ideas.